The following is an overview of the user manual for the Z-Wave product Z-WAVE 700 Keypad (7BA-KP-V-B-A0)from LEEDARSON. To view other Z-Wave products and manuals from Leedarson follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-WAVE 700 Keypad supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
Features
Leedarson describes Z-WAVE 700 Keypad as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
NA
Remove the Keypad from a Z-Wave network:
1. Set the Z-Wave network main controller into removing mode (see Z-Wave controller operating manual).
2. Trigger this button action. the Network LED will flashing at every 1 second.
3. If the removing is successful, the LED will solid green for 3 seconds. If the removing is failed then LED display yellow for 3 seconds, otherwise you need to repeat the process from step 2.
Note: Keypad will start SmartStart Inclusion when it is removed from a Z-wave network.
Turn on/off arm status indicate after wake up
Factory reset Z-WAVE 700 Keypad
Reset the Keypad to factory default.
1. Device will reset itself to factory default by sending a “Device Reset Locally Notification” to gateway.
2. If triggered the factory reset, the network connection led will solid green while factory reset is completed.
Note: Please use this procedure only when the network primary controller is missing or otherwise inoperable.
NA
SmartStart location
SmartStart QR code's location as follows: on the side of the product
Add the Keypad into the Z-Wave network via SmartStart:
1. Add Keypad DSK into the primary controller SmartStart Provisioning List (If you don’t know how to do this, refer to its manual).
2. Power on the Keypad again.
3. The Keypad will send “Z-Wave protocol Command Class” frame to start SmartStart Inclusion.
4. Network green LED will flashing at every 1 second to indicate that the inclusion is working, and solid green LED 3 seconds for indicate the inclusion is successful, otherwise the LED will be soild yellow in which you need to repeat the process from step 2
Note: Keypad will reset itself to factory default by sending “Device Reset Locally CC” when it is included into a non-security Z-wave network.
DSK QR code is on the left side of the product with laser printing.
User should follow the procedure in the section below if the controller does not support SmartStart inclusion.
Add the Keypad into the Z-Wave network:
1. Set the Z-Wave network main controller into learning mode (see Z-Wave network controller operating manual).
2. Trigger this action.
3. Network green LED will flashing at every 1 second to indicate that the inclusion is working, and solid green LED 3 seconds for indicate the inclusion is successful, otherwise the LED will be soild yellow in which you need to repeat the process from step 2.
Please note that this is a user manual Z-WAVE 700 Keypad from LEEDARSON is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-WAVE 700 Keypad and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.