The following is an overview of the user manual for the Z-Wave product Z-WAVE 700 Keypad (7BA-KP-V-B-C0)from LEEDARSON. To view other Z-Wave products and manuals from Leedarson follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-WAVE 700 Keypad supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
Features
Leedarson describes Z-WAVE 700 Keypad as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Set the Z-Wave network main controller into learning mode (see Z-Wave network controller operating manual).
2. Trigger this action.
3. Network green LED will flashing at every 1 second to indicate that the inclusion is working, and solid green LED 3 seconds for indicate the inclusion is successful, otherwise the LED will be soild yellow in which you need to repeat the process from step 2.
Remove the Keypad from a Z-Wave network:
1. Set the Z-Wave network main controller into removing mode (see Z-Wave controller operating manual).
2. Trigger this button action. the Network LED will flashing at every 1 second.
3. If the removing is successful, the LED will solid green for 3 seconds. If the removing is failed then LED display yellow for 3 seconds, otherwise you need to repeat the process from step 2.
Note: Keypad will start Smart Start Inclusion when it is removed from a Z-wave network.
Turn on/off arm status indicate after wake up
Turn on: 1
Turn off: 0
Factory reset Z-WAVE 700 Keypad
Keypad will reset itself to factory default by sending “Device Reset Locally CC” when it is included into a non-security Z-wave network.
NA
NA
SmartStart location
SmartStart QR code's location as follows: on page 5
Please note that this is a user manual Z-WAVE 700 Keypad from LEEDARSON is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-WAVE 700 Keypad and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.