The following is an overview of the user manual for the Z-Wave product Z-WAVE 700 Motion Sensor Pet Immunity (7CA-SS-VE-A0)from LEEDARSON. To view other Z-Wave products and manuals from Leedarson follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-WAVE 700 Motion Sensor Pet Immunity supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Leedarson describes Z-WAVE 700 Motion Sensor Pet Immunity as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
NA
NA
NA
SmartStart location
SmartStart QR code's location as follows: on the saide of the product
Add the Motion Sensor into the Z-Wave network:
5. Power on your Motion Sensor, and let your Z-Wave controller into add/inclusion mode.
6. 3 consecutive clicks in 1.5 seconds, the Motion Sensor will send out a node info security CC in command class list (Security inclusion), the LED will be fast blink ,the timeout is 20-40 seconds;
7. If the inclusion is successful, the LED will be turn on within 2 seconds. If failed, LED will be turn off forever, and please repeat the steps in above.
Remove Motion Sensor from a Z-Wave network:
1. Power on your Motion Sensor, and let the Z-Wave primary controller into remove mode.
2. 3 consecutive clicks in 1.5 second, the LED will be fast blink ,the timeout is 20-40 seconds;
3. If Motion Sensor has been successfully removed from your Z-Wave
network, the LED will be turn on 2 seconds. If failed, LED will be turn off forever, and please repeat the steps in above.
In the network: Send Wake up notification, and LED will fast blink when
sending data, send over then the LED turn off.
Factory reset Z-WAVE 700 Motion Sensor Pet Immunity
Reset Motion Sensor to factory default.
1. Triggering this action, in 5 seconds LED will be accelerate blink. After 5 seconds, the LED will remain on until the key is released. Motion Sensor will send “Device_Reset_Locally” to the main controller and exclude from the Z-Wave network when the button is released, this procedure will reset the sensor to factory default.
2. Please use this procedure only when the network primary controller is missing or otherwise inoperable.
3. When not in the network, triggering this action, in 5 seconds LED will be accelerate blink red. After 5 seconds, the LED will remain on red until the key is released. this procedure will reset the sensor to factory default.
Please note that this is a user manual Z-WAVE 700 Motion Sensor Pet Immunity from LEEDARSON is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-WAVE 700 Motion Sensor Pet Immunity and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.