The following is an overview of the user manual for the Z-Wave product Receptacle (ZW15R)from Leviton. To view other Z-Wave products and manuals from Leviton follow that link.
Overview
Security
As a Z-Wave Plus certified product, Receptacle supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Leviton describes Receptacle as having the following features:
- Switch Load Capacity Volt-Ampere
- Neutral Wire Required
- Z-Wave Scene Type
- Firmware updatable via a compatible Z-Wave gateway
- Electric Load Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Page 8
Exclusion From A Z-Wave Network
When removing an outlet from a Z-Wave network, best practice is to use the exclusion command found in the Z-Wave controller.
1. To enter programming mode, hold the button for 7 seconds. The status light will turn amber, release and the status light will blink.
2. Follow Z-Wave controller directions to enter exclusion mode
3. Tap the button 1 time. The status light will quickly flash green.
4. The Z-Wave controller will remove the device from the network
Classic Inclusion To A Z-Wave Network
For older controllers Classic Inclusion is supported. Depending on the age of the controller the controller will need to be 3 to 35 feet from the device when including.
1. To enter programming mode, hold the button for 7 seconds. The status light will turn amber, release and the status light will blink.
2. Follow the Z-Wave controller instructions to enter exclusion mode.
3. Tap the top of the button one time. The status light will quickly flash green.
4. The Z-Wave controller will confirm successful exclusion from the network.
Factory reset Receptacle
Factory Default
When removing an outlet from a network it is best practice to use the exclusion process. In situations where a device needs to be returned to factory default follow the following steps. A reset should only be used when a controller is inoperable or missing.
1. Hold the button for 7 seconds, the status light will turn amber. Continue holding the button for another 7 seconds (total of 14 seconds). The status light will quickly flash red/amber.
2. Release the button and the device will reset.
Please note that this is a user manual Receptacle from Leviton is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Receptacle and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.