The following is an overview of the user manual for the Z-Wave product Home IoT Hub (IHU50)from LG Uplus. To view other Z-Wave products and manuals from LG follow that link.
Overview
Security
As a Z-Wave Plus certified product, Home IoT Hub supports Z-Wave S2 security. The following security modes are directly supported:
Features
LG describes Home IoT Hub as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Select ‘Controller’ in [Node List]
Select ‘Add’ in [Command List]
Click Send(Default) button.
Option 1) Classic
Change parameters in [Value]: ADD_NODE_OPTION_NETWORK_WIDE:”0”
Option 2) Network Wide
Change parameters in [Value]: ADD_NODE_OPTION_NETWORK_WIDE:”1”
Option 2) Low Power
Change parameters in [Value]: ADD_NODE_OPTION_HIGH_POWER : “0”
Select ‘Remove’ in [Command List]
Click Send(Default) button.
Select ‘setLearnMode’ in [Command List]
Click Send(Default) button.
Factory reset Home IoT Hub
Select ‘setDefault’ in [Command List]
Click Send(Default) button.
Please note that this is a user manual Home IoT Hub from LG Uplus is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Home IoT Hub and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.