The following is an overview of the user manual for the Z-Wave product IoT Hub (GWG-02)from LG Uplus. To view other Z-Wave products and manuals from LG follow that link.
Overview
Security
As a Z-Wave Plus certified product, IoT Hub supports Z-Wave S2 security. The following security modes are directly supported:
Features
LG describes IoT Hub as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
- To Add : Run ‘Inclusion’ in Setting, then click YES of Inclusion PoP UP and then run inclusion of Slave device.
- To Delete : Run ‘Exclusion’ in Setting, then click YES of Exclusion PoP UP and then run exclusion of Slave device.
- To enter Learn Mode : Run ‘LearnMode’ in Setting, then click YES.
Factory reset IoT Hub
- Run ‘ZW_SET_DEFAULT’ in Setting, then click YES of UZB PoP UP
- Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual IoT Hub from LG Uplus is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have IoT Hub and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.