The following is an overview of the user manual for the Z-Wave product Open Sensor (OSLI-01)from LG Uplus. To view other Z-Wave products and manuals from LG follow that link.
Overview
Security
As a Z-Wave Plus certified product, Open Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
LG describes Open Sensor as having the following features:
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Press & hold inclusion/Exclusion button during 5 seconds when Open Sensor is exclusion status.
2. Press for 5 seconds, LED is turn on.
3. Open sensor will try inclusion for 30 seconds when button is released.
1. Receiver will stay exclusion waiting mode.
2. Press & hold inclusion/Exclusion button during 5 seconds when Open Sensor is exclusion status.
3. Press for 5 seconds, LED is turn on.
4. Open sensor will try exclusion when button is released.
5. If exclusion is successful, LED will blink 3 times with 250ms interval.
Factory reset Open Sensor
1. Press & hold inclusion/Exclusion button during 10 seconds.
2. LED will blink while holding the button.
3. Factory reset will be done in 10 seconds after releasing button and blink 5 times with 100ms interval.
※ Please use factory reset only when the network primary controller is missing or otherwise inoperable.
1. Device sends Wake up Notification by every 15 minutes.
2. Devices also sends Wake up Notification when inclusion/exclusion button is shortly pressed regardless of 15minutes interval.
Firmware auto update via over the air
Please note that this is a user manual Open Sensor from LG Uplus is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Open Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.