The following is an overview of the user manual for the Z-Wave product Open Sensor (OSR-01H)from LG Uplus. To view other Z-Wave products and manuals from LG follow that link.
Overview
Detecting the status of Door/Windows equipped with Z-WAVE Open Sensor and notifying the status to a customer.
Checking the battery usage and reporting the low battery alarm.
Security
As a Z-Wave Plus certified product, Open Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
LG describes Open Sensor as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
a. Press & hold Inclusion/Exclusion button for 5 seconds when Open Sensor is
exclusion status.
b. LED of Open sensor will be on 5 seconds later.
c. Open sensor will try Inclusion for 30sec when button is released.
d. LED will blink 3 times if Inclusion is successful.
a. Receiver will stay exclusion waiting mode.
b. Press & hold Inclusion/Exclusion button for 5 seconds when Open Sensor is
Inclusion status.
c. LED of Open sensor will be on 5 seconds later.
d. Open sensor will try Exclusion when button is released.
e. LED will blink 3 times if Exclusion is successful.
a. Device sends Wake up Notification by every 15 minutes.
b. Devices also sends Wake up Notification when inclusion/exclusion button is shortly pressed regardless of 15minutes interval.
a. Firmware auto upgrade via OTA.
Factory reset Open Sensor
a. Press & hold Inclusion/Exclusion button for 10sec.
b. LED will blink while holding the button.
c. Factory reset will be done in 5sec after releasing button and LED will blink 5 times.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Open Sensor from LG Uplus is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Open Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.