Siren (SIR-01) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Siren (SIR-01)from LG U+. To view other Z-Wave products and manuals from LG follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Siren
SKU Code
SIR-01
Description
Siren will detect the movement of people or animals in real time and then report it to Z-Wave gateway (LTE Router) through the Z-Wave protocol.
It Will be used with AA Battery, Battery life time is 1year.
And it can be installed easily by using double side tape.
Version #
HW: 18 FW: 39.36 was the version certified
Certification #
ZC10-17065638
Certified
2017-05-25T18:18:49.590632
Z-Wave Version
6.61.00

Security

As a Z-Wave Plus certified product, Siren supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    LG describes Siren as having the following features:

    • Firmware updatable via a compatible Z-Wave gateway
    • Battery Quantity
    • Color
    • Switch Type
    • Battery powered using AA Battery batteries
    • IP (Ingress Protection) Rated
    • Outdoor Use
    • Supported Notification Types
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Press the action button for 5 seconds
    2. Green LED is turned on after pressing 5 seconds of action button
    3. Inclusion will be discontinued once the product is removed from the network
    4. If the device is successfully excluded, the Green LED blinks 3 times

    1. Press & hold action button for 5 seconds when siren is in the excluded status
    2. LED of siren will be on 5 seconds later
    3. Siren will try inclusion for 1 minute when action button is released
    4. LED will blink 3 times with 250ms interval if inclusion is successful

    Factory reset Siren

    1. Press the action button for 10 seconds
    2. The Green LED is turned on after pressing 10 seconds of the action button
    3. If the Device is removed (factory reset), the Green LED blinks 5 times

    ※ Please use this procedure only when the network primary controller is
    missing or otherwise inoperable

    The device can be made to wake-up prior to the normal wake-up interval by pressing the action button.

    Please note that this is a user manual Siren from LG U+ is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Siren and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.