The following is an overview of the user manual for the Z-Wave product Smart Button (IBDK-01)from LG U+. To view other Z-Wave products and manuals from LG follow that link.
Overview
Security
As a Z-Wave Plus certified product, Smart Button supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
LG describes Smart Button as having the following features:
- Battery Quantity
- Battery powered using AAA batteries
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
0. Put Controller into inclusion mode
1. Open battery cover
2. Press and hold the button there
3. LED is turned on after 5 seconds
4. Release the button when the LED is turned on
0. Put Controller into exclusion mode
1. Open battery cover
2. Press and hold the button there
3. LED is turned on after 5 seconds
4. Release the button when the LED is turned on
Factory reset Smart Button
Please excute this reset procedure only when the primary controller is missing or inoperable.
1. Open battery cover.
2. Press and hold the button there
3. LED is turned on after 5 seconds. Keep holding.
4. LET starts blinking after 10 seconds.
5. Release the button when the LED blinks
1. Open battery cover.
2. Press and hold the button there
Please note that this is a user manual Smart Button from LG U+ is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Button and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.