The following is an overview of the user manual for the Z-Wave product Smart Gas Controller (GCR-01)from LG Uplus. To view other Z-Wave products and manuals from LG follow that link.
Overview
Security
As a Z-Wave Plus certified product, Smart Gas Controller supports Z-Wave S2 security. The following security modes are directly supported:
Features
LG describes Smart Gas Controller as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
This must be done at Gas valve is close. After doing inclusion action on controller, then hold 5 seconds (-) button till hearing beep once and ‘P’ is blinking on LCD.
This must be done at Gas valve is close. After doing exclusion action on controller, then hold 5 seconds (-) button till hearing beep once and ‘P’ is blinking on LCD.
Factory reset Smart Gas Controller
Please use this only when the primary controller is missing or otherwise disabled.
This must be done at Gas valve is close. Hold 15 seconds (-) button till hearing beep once and ‘FS’ is displayed on LCD.
Please note that this is a user manual Smart Gas Controller from LG Uplus is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Gas Controller and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.