The following is an overview of the user manual for the Z-Wave product Smart Plug (SPES - 02A)from LG Uplus. To view other Z-Wave products and manuals from LG follow that link.
Overview
It measures its power consumption & sends that information
to your smartphone . It can also control power source
connected with appliance manually and remotely using
smartphone.
Security
As a Z-Wave Plus certified product, Smart Plug supports Z-Wave S2 security. The following security modes are directly supported:
Features
LG describes Smart Plug as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Watts
- Supported Meter Type
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Put your Z-Wave controller into exclusion mode
2. Plug the SmatPlug into the power outlet.
3. Press and hold on/off button about 5 seconds.
4. Orange LED will be flashing about 2 seconds, then exclusion process will be start.
5. Wait until exclusion will be done.
1. Put your Z-Wave controller into inclusion mode.
2. Plug the SmatPlug into the power outlet.
3. Press and hold on/off button about 5 seconds.
4. Orange LED will be flashing about 2 seconds, then inclusion process will be start.
5. Wait until inclusion will be done.
Factory reset Smart Plug
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
1. Plug the SmatPlug into the power outlet.
2. Press and hold on/off button about 10 seconds.
3. Orange LED will be flashing about 2 seconds, then factory reset process will be start.
Please note that this is a user manual Smart Plug from LG Uplus is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Plug and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.