The following is an overview of the user manual for the Z-Wave product Smart Switch (SSD-305)from LG U+ IoT@Home. To view other Z-Wave products and manuals from LG follow that link.
Overview
You can control the light from the remote.
Input AC power : 220V
Security
As a Z-Wave Plus certified product, Smart Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
LG describes Smart Switch as having the following features:
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Supported Notification Types
- Color
- Switch Load Capacity Current
- Outdoor Use
- Switch Load Capacity Volt-Ampere
- Switch Load Capacity Watts
- Switch Type
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
After mounting the UZB controller to your PC and running the PC Controller program, click the Add button in the PC Controller program. Press the button on the Smart Power Strip for more than five seconds after you plug the Smart Power Strip into a power outlet and it will include to the network controller, while flashing the red button on the LED Smart Power Strip.
After mounting the UZB controller to your PC and run the PC Controller program you can click the Remove button in the PC Controller program. Press the button on the Smart Power Strip for more than five seconds after you plug the Smart Power Strip into a power outlet will Exclusion in the network controller, while the flashing red button LED Smart Power Strip.
The device measures ambient temperature and humidity and reports periodically.
The cycle can be changed through the Configuration Command Class.
Factory reset Smart Switch
With the device powered, press and hold the third button for 10 seconds.
he LED of the button will flash red after 5 seconds, it will turn green, then it will flash red again. Then release the button.
After a few moments, the entire LED is blinking and the green LED stops flashing.
Please use the procedure only in the event thant the network primary controller is missing or otherwise inoperable.
To wake up this device, either press the switch button or try remote control.
Please note that this is a user manual Smart Switch from LG U+ IoT@Home is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.