The following is an overview of the user manual for the Z-Wave product U+ IoT Switch (SSE-304)from LGU+ IoT@home. To view other Z-Wave products and manuals from LG follow that link.
Overview
- It is easy to install.
- Support 480(Watt) light power capacity.
- Support temperature & humidity measurement.
- Notification function for malfunction.
Security
As a Z-Wave Plus certified product, U+ IoT Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
LG describes U+ IoT Switch as having the following features:
- Sensors
- Firmware updatable via a compatible Z-Wave gateway
- Supported Notification Types
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
This device supports temperature & humidity measurement function.
Factory reset U+ IoT Switch
1) Hold the low touch button for 10 seconds.
- Keep holding the button, then at 5 second, red LED of 3rd
button is blinking 6 times and keep holding10 seconds
later, red LED of 3rd is blinking 6 times again. In this time
factory reset will be started if you release the button.
2) After factory reset is done, all the lamps will be turned off
and all variables will be initialized to default values.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
▶ Add / Remove by the button in the bottom (3rd Button)
▶ Press the 3rd button for above 5 seconds,
- Then, red color LED blinks every 0.5 second 6 times.
- At this time released the button during the red color LED
blinking.
- Then, ZWAVE Add / Remove operation is started.
- Over 30 seconds, Inclusion/ Exclusion mode is stopped.
▶ Press the 3rd button for above 5 seconds,
- Then, red color LED blinks every 0.5 second 6 times.
- At this time released the button during the red color LED
blinking.
- Then, ZWAVE Add / Remove operation is started.
- Over 30 seconds, Inclusion/ Exclusion mode is stopped.
Please note that this is a user manual U+ IoT Switch from LGU+ IoT@home is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have U+ IoT Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.