The following is an overview of the user manual for the Z-Wave product Woofer IoT (LAP255U)from LG Uplus. To view other Z-Wave products and manuals from LG follow that link.
Overview
Security
As a Z-Wave Plus certified product, Woofer IoT supports Z-Wave S2 security. The following security modes are directly supported:
Features
LG describes Woofer IoT as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Run Z-Wave Certification Application in Setting, Select ""Things"" on the left menu, Select ""bridge"" on the right list, and Select addThing on the right list, push Send button on the Pop up, and then run inclusion of Slave device.
Run Z-Wave Certification Application in Setting, Select ""Things"" on the left menu, select ""bridge"" on the right list, and Select removeThing on the right list, push Send button on the Pop up, and then run exclusion of Slave device.
Run Z-Wave Certification Application in Setting, Select ""Things"" on the left menu, select ""bridge"" on the right list, and Select setLearnMode on the right list, push Send button on the Pop up.
Factory reset Woofer IoT
Run Z-Wave Certification Application in Setting, Select ""Things"" on the left menu, select ""bridge"" on the right list, andd Select factoryReset on the right list, push Send button on the Pop up.
Please note that this is a user manual Woofer IoT from LG Uplus is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Woofer IoT and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.