The following is an overview of the user manual for the Z-Wave product S30 Base (S30)from LifeShield. To view other Z-Wave products and manuals from LifeShield follow that link.
Overview
Security
As a Z-Wave Plus certified product, S30 Base supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
- S2 Authenticated
- S2 Unauthenticated
Features
LifeShield describes S30 Base as having the following features:
- Communications Protocol
- Firmware updatable via a compatible Z-Wave gateway
- Battery powered using Proprietary 3-cell 18650 LiIon batteries
- Communications Connections
- Color
- Sensors
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. To add a Z-Wave device,
3. Enter master code. Navigate to Settings.
2. Choose devices.
4. Click on the add button.
5. Choose the type of device you would like to add to the system.
6. The system willthen enter z-wave add mode.
7. Now follow the instructions provided by your device for including it in a Z-Wave network.
To remove a device from the Z-Wave network, go
to settings -> Devices as you would when adding a
new device, but instead of selecting the ‘+’ icon to
add a new device, select the device you would like
to remove
Select ‘Remove’. The LifeShield system will enter
exclusion mode to prepare for the removal. Follow
the instructions provided with your device to
exclude it from the Z-Wave network (this is often the
same procedure you used to include the device).
Once the device is removed, you will hear a
confirmation beep from the LifeShield base to
confirm that the device has been removed.
Factory reset S30 Base
RESETTING YOUR Z-WAVE NETWORK
In order to factory reset your Z-Wave network,
navigate to the Z-Wave Utilities page under Settings.
Select “Z-Wave Reset Controller”
After a few seconds, the LifeShield base will beep to indicate that your Z-Wave network has been reset. Any devices which were part of your Z-Wave network will need to be reset before they can be re-added. Use the Z-Wave General Exclusion menu under Z-Wave Utilities to do this.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
If you would like to add the LifeShield base
into another Z-Wave network, you must first delete
all Z-Wave devices from the LifeShield base before
proceeding.
Once all devices have been deleted, follow the
instructions on the other controller to put it into
add mode. Once the other Z-Wave controller is in
add mode, you can place the LifeShield base into
learn mode by navigating to the settings page and
choosing Z-Wave Utilities.
From this menu, select Z-Wave Learn Mode to put
the LifeShield base into learn mode.
Follow the instructions on the other controller
to complete the add process. Once the add is
complete, the LifeShield base will request a copy
of the other Z-Wave network configuration, and the
network devices will appear on the LifeShield IOS,
Android, and web applications.
When the LifeShield base is included in another
Z-Wave network, it will ignore Basic Z-Wave
commands that are sent to it.
Please note that this is a user manual S30 Base from LifeShield is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have S30 Base and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.