The following is an overview of the user manual for the Z-Wave product Ultimate Thermostat (ST1000EZ0)from LinkedGO. To view other Z-Wave products and manuals from LinkedGO follow that link.
Overview
We also have fashionable appearance, the depth only 0.39 inch (10mm).
Security
As a Z-Wave Plus certified product, Ultimate Thermostat supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
LinkedGO describes Ultimate Thermostat as having the following features:
- Color
- Communications Connections
- Thermostat Modes
- Thermostat Power Source
- Communications Protocol
- Firmware updatable via a compatible Z-Wave gateway
- Neutral Wire Required
- Sensors
- Supported Notification Types
- Thermostat HVAC Systems Supported
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Support different style background theme. Go to ""Theme"" choose your favourite one.
Hold the ""+"" button 5 seconds, until the display show ""Add"".
Hold the ""-"" button 5 seconds, until the display show ""Remove"".
Factory reset Ultimate Thermostat
Go to the third page, find ""About"", select ""Reset all settings"", and confirm.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Ultimate Thermostat from LinkedGO is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Ultimate Thermostat and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.