The following is an overview of the user manual for the Z-Wave product Dimmer Wall Switch (ZDB5100)from Logic Group A/S. To view other Z-Wave products and manuals from Logic Group follow that link.
Overview
Each pushbutton is a tactile switch designed that can hold up to four functions and control either a wired lamp or other Z-Wave devices, e.g. other light dimmers, roller shutters and power outlets.
The light dimmer can dim all dimmable light sources from 0-250 W.
MATRIX ZDB5100 is designed to fit into all FUGA® compatible wall boxes and cover frames.
Security
As a Z-Wave Plus certified product, Dimmer Wall Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Logic Group describes Dimmer Wall Switch as having the following features:
- Switch Load Capacity Watts
- Switch Type
- Z-Wave Scene Type
- Switch Load Capacity Volt-Ampere
- Color
- Firmware updatable via a compatible Z-Wave gateway
- IP (Ingress Protection) Rated
- Neutral Wire Required
- Electric Load Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Remove white pushbutton cover and press on the center switch with a non-conductive object. The LEDs will now start blinking on pushbutton 1 (upper left pushbutton)
Remove white pushbutton cover and press on the center switch with a non-conductive object. The LEDs will now start blinking on pushbutton 1 (upper left pushbutton)
Factory reset Dimmer Wall Switch
Remove white pushbutton cover and long-press the center switch for 10 seconds with a non-conductive object.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Dimmer Wall Switch from Logic Group A/S is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Dimmer Wall Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.