The following is an overview of the user manual for the Z-Wave product Dimmer Wall Switch (ZDB5400)from Logic Group A/S. To view other Z-Wave products and manuals from Logic Group follow that link.
Overview
Each square is a tactile switch that can hold up to four functions and control either a wired lamp or other Z-Wave devices, e.g. other light dimmers, roller shutters and power plugs. The pushbuttons can send ’ON’, ’OFF’ and ’DIM’ commands to associated Z-Wave devices.
The light dimmer can dim all dimmable light sources from 0-250 W.
MATRIX 55 fits in standard 60mm CE boxes. Examples of compatible cover frames are GIRA System 55, Exxact and Elko Plus. The insert is also compatible with GIRA pushbutton sensor 2.
Security
As a Z-Wave Plus certified product, Dimmer Wall Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Logic Group describes Dimmer Wall Switch as having the following features:
- Neutral Wire Required
- Switch Load Capacity Volt-Ampere
- Switch Load Capacity Watts
- Switch Type
- Z-Wave Scene Type
- Firmware updatable via a compatible Z-Wave gateway
- Electric Load Type
- Color
- IP (Ingress Protection) Rated
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Find the DSK, QR code and PIN Code on the front of the insert module.
Use same procedure for removing MATRIX 55 with Classic Exclusion.
Factory reset Dimmer Wall Switch
MATRIX can be factory reset by holding the switch through the hole (I) for at least 10 seconds.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Add MATRIX 55 to a network with Classic Inclusion by pressing once on the switch through the hole (I) with a non-conductive object. The LED inside the module will start blinking.
Please note that this is a user manual Dimmer Wall Switch from Logic Group A/S is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Dimmer Wall Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.