The following is an overview of the user manual for the Z-Wave product Gateway (LCP300-L)from Lyric. To view other Z-Wave products and manuals from Lyric follow that link.
Overview
This Gateway system can include wireless sensors to provide burglary protection and smoke and combustion detectors to provide early fire and carbon monoxide (CO) warnings (if installed).
This Gateway system monitors sensors and system status to initiate alarms and generate alerts. The system can also send alarm and status messages to a central monitoring station via the cellular phone network or the Internet, if programmed to do so.
This Gateway system and Z-Wave devices added to the system are linked together in a wireless network. Each device in the network is assigned a unique address and cannot be activated by a neighbor's Z-Wave controller. The Z-Wave network supports multiple controllers, allowing Z-Wave remote controls to be used throughout the home.
This Gateway system can display live video from as many as eight Wi-Fi-connected cameras.
This Gateway system uses 4-digit codes to restrict certain functions to selected users. A special 4-digit code can be set to trigger the system’s Duress function.
Security
As a Z-Wave Plus certified product, Gateway supports Z-Wave S2 security. The following security modes are directly supported:
Features
Lyric describes Gateway as having the following features:
- Battery Quantity
- Battery powered using Great Power NI-MH Battery, 7.2V 1100mAh batteries
- Color
- Communications Connections
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Press ""Automation"" on the Home screen, the Z-wave Device Management screen appears. Press the ""Down"" arrow. Press ""Tools"" and select ""Exclude Devices"".
Press ""Automation"" on the Home screen, the Z-wave Device Management screen appears. Press the ""Down"" arrow. Press ""Tools"" and select ""Include Devices"".
Factory reset Gateway
Press ""Automation"" on the Home screen, the Z-wave Device Management screen appears. Press the ""Down"" arrow. Press ""Tools"" and select ""Advanced Tools"". Enter the Master User code: 1234, the Advanced Tools screen appears and select ""Factory Default Controller"".
Note: If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable
Press ""Automation"" on the Home screen, the Z-wave Device Management screen appears. Press the ""Down"" arrow. Press ""Tools"" and select ""Advanced Tools"". Enter the Master User code: 1234, the Advanced Tools screen appears and select ""Learn"".
Please note that this is a user manual Gateway from Lyric is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Gateway and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.