The following is an overview of the user manual for the Z-Wave product MATRIX Creator (MATRIX.C1.US)from MATRIX Labs. To view other Z-Wave products and manuals from MATRIX Labs follow that link.
Overview
From a hardware perspective, MATRIX Creator is an all inclusive solution, consolidating an ultraviolet sensor, pressure sensor, 3D accelerometer, 3D gyroscope, 3D magnetometer, humidity sensor, 8 MEMs microphone array, a temperature sensor, 35 RGBW LEDs array, as well as a Xilinx Spartan 6 FPGA and an Atmel ARM Cortex M3 microcontroller. Connectivity and communication standards are equally abundant, consisting of Zigbee, Z-Wave, NFC, IR RX/TX, 2 ADC Channels, 17 digital GPIOs, SPI, I2C, UART.
https://creator.matrix.one/
Security
As a Z-Wave Plus certified product, MATRIX Creator supports Z-Wave S2 security. The following security modes are directly supported:
Features
MATRIX Labs describes MATRIX Creator as having the following features:
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Current
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
MATRIX Creator is a Z-Wave Plus Hardware Platform Product. It provides communication with the Z-Wave SerialAPI running on the Z-Wave module in the MATRIX Creator. Refer to Sigma design Z-Wave Specification (http://zwavepublic.com/specifications) and developer resources (http://zwavepublic.com/developer).
MATRIX Creator is a Z-Wave Plus Hardware Platform Product. It provides communication with the Z-Wave SerialAPI running on the Z-Wave module in the MATRIX Creator. Refer to Sigma design Z-Wave Specification (http://zwavepublic.com/specifications) and developer resources (http://zwavepublic.com/developer).
Factory reset MATRIX Creator
Factory reset should be done by software. Please refer to the documentation (https://matrix-io.github.io/matrix-documentation/API/zwave/)
For more information:
- https://creator.matrix.one/
- https://matrix-io.github.io/matrix-documentation/
- https://matrix-io.github.io/matrix-documentation/API/zwave/
- https://github.com/matrix-io
MATRIX Creator is a Z-Wave Plus Hardware Platform Product. It provides communication with the Z-Wave SerialAPI running on the Z-Wave module in the MATRIX Creator. Refer to Sigma design Z-Wave Specification (http://zwavepublic.com/specifications) and developer resources (http://zwavepublic.com/developer).
Please note that this is a user manual MATRIX Creator from MATRIX Labs is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have MATRIX Creator and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.