The following is an overview of the user manual for the Z-Wave product 9 in 1 MULTI-SENSOR (A8-9)from MCOHOME. To view other Z-Wave products and manuals from MCO Home follow that link.
Overview
Security
As a Z-Wave Plus certified product, 9 in 1 MULTI-SENSOR supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
MCO Home describes 9 in 1 MULTI-SENSOR as having the following features:
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Activate Remove mode in the gateway. When device is powered on, hold F1 to choose interface for Remove Z-Wave network. Click F2 five times until double curved arrow icon turns blue. Hold F2 and the device enters into learning mode, then Wifi icon turns blue and the device is removed from Z-Wave network.
Factory reset 9 in 1 MULTI-SENSOR
1, Press & hold F1 to enter Z-Wave setting interface, then press & hold F1 again to enter parameters setting interface;
2, Press & hold F2 to enter setting interface and select “default”;
3, Click F2 3 times and displays “OFF”-->“ON”-->“OK”-->“OFF”, factory setting is restored.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Activate Add mode in the gateway. When device is powered on, hold F1 to choose interface for Add Z-Wave network. Click F2 five times until double curved arrow icon turns blue. Hold F2 and the device enters into learning mode, then Wifi icon turns blue and the device is added into Z-Wave network.
Please note that this is a user manual 9 in 1 MULTI-SENSOR from MCOHOME is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 9 in 1 MULTI-SENSOR and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.