Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Heat Pump Thermostat (MH6-HP) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Heat Pump Thermostat (MH6-HP)from MCO Home. To view other Z-Wave products and manuals from MCO Home follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Heat Pump Thermostat
SKU Code
MH6-HP
Description
MH6-HP programmable thermostat is a Z-Wave Plus enabled device for indoor temperature control. It is mainly applied to heat pump system for heating/cooling, with 3 modes easily switchable: Schedule, Hold and Holiday. The device is of high reliability and practicability, and it can support up to 3H/2C system. This product can be included and operated in any Z-Wave network with other Z-Wave certified devices from any other manufacturers.
Version #
HW: 255 FW: 3.04 was the version certified
Certification #
ZC10-18086210
Certified
2018-08-16T17:56:40.780403
Z-Wave Version
6.71.03

Security

As a Z-Wave Plus certified product, Heat Pump Thermostat supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Unauthenticated

Features

MCO Home describes Heat Pump Thermostat as having the following features:

  • Firmware updatable via a compatible Z-Wave gateway
  • Switch Load Capacity Current
  • Neutral Wire Required
  • Outdoor Use
  • Sensors
  • Thermostat HVAC Systems Supported
  • Thermostat Modes
  • Thermostat Power Source
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

In normal display, press & hold ^ button to enter interface for adding Z-Wave network. Before device added into network, “- - -” will display on the screen. Then press ^ once, device will enter learning mode to get a node ID. If adding is successful, a Node ID will display on the screen in a few seconds.

In normal display, press & hold ^ button to enter interface for removing of Z-Wave network. A Node ID will display on the screen. Then press ^ button once, “- - -” will display on the screen to show removal was successful.

Factory reset Heat Pump Thermostat

1、Remove the device from Z-Wave network can restore factory setting.
2、Configure the parameter 10 in secret menu can restore the factory setting also. Please use this procedure only when the network primary controller is missing or otherwise inoperable.

Please note that this is a user manual Heat Pump Thermostat from MCO Home is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Heat Pump Thermostat and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.