The following is an overview of the user manual for the Z-Wave product Micro Dimmer (MH-P220)from MCO Home. To view other Z-Wave products and manuals from MCO Home follow that link.
Overview
Security
As a Z-Wave Plus certified product, Micro Dimmer supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
MCO Home describes Micro Dimmer as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Current
- Neutral Wire Required
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Add the device into Z-Wave network:
1. Set controller into ADD mode. Follow the instructions provided by the controller/gateway manufacturer.
2. Press the momentary button on the device 3 times, or the connected external button S1 3 times in quick succession.
Note: If the ADD is successful, the INDICATION LED will blink 6 times. If not, INDICATION LED will be solid on or off depending on switch’s state.
Remove the device from Z-Wave network:
1. Set controller into REMOVE mode. Follow the instructions provided by the controller/gateway manufacturer.
2. Press the momentary button on the device 3 times, or the connected external button S1 3 times in quick succession.
Note: If the REMOVE is successful, the INDICATION LED will blink 6 times. If not, INDICATION LED will be solid on or off depending on switch’s state.
Factory reset Micro Dimmer
Restoring Factory Settings:
The default configuration can be restored by:
Sending commands through controller/gateway (the command classes which support this function is Configuration Command Class). The parameter are as follows:
Parameter Number 0xFF
Size 1 BYTE
Default value N/A
Configuration value 0x55
Set 0xFF as 0x55 will restore Factory Settings.
Or press the inner button on the module 10 times in quick succession.Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Micro Dimmer from MCO Home is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Micro Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.