The following is an overview of the user manual for the Z-Wave product Touch Panel Switch (MH-S510 series)from MCO Home. To view other Z-Wave products and manuals from MCO Home follow that link.
Overview
Security
As a Z-Wave Plus certified product, Touch Panel Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
MCO Home describes Touch Panel Switch as having the following features:
- Neutral Wire Required
- Switch Load Capacity Current
- Z-Wave Scene Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Touch Panel Switch
Press 20 times of any button (the interval time of touching is less than 500 milliseconds and the relay will keep same state after continually touching more than five times) or exclude the device from Z-Wave network, the factory setting will be restored.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
1. Set controller into ADD mode. Follow instructions provided by controller manufacturer.
2. Press and hold any key on the panel for 8 seconds or 3 clicks in quick succession.
Note: If the ADD is successful, all INDICATION LEDs on the panel will flash 4 times.
1. Set controller into REMOVE mode. Follow instructions provided by controller manufacturer.
2. Press and hold any key on the panel for 8 seconds or 3 clicks in quick succession.
Note: If the REMOVE is successful, all INDICATION LEDs on the panel will flash 4 times. The REMOVE will delete all association data.
Please note that this is a user manual Touch Panel Switch from MCO Home is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Touch Panel Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.