The following is an overview of the user manual for the Z-Wave product IoT hub (MC01-507L)from Mercury. To view other Z-Wave products and manuals from Mercury follow that link.
Overview
Security
As a Z-Wave Plus certified product, IoT hub supports Z-Wave S2 security. The following security modes are directly supported:
Features
Mercury describes IoT hub as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
You can add the device ether hardware button or application.
- Hard ware button : Press the Add/Remove button(Start Z-Wave LED blink)
- Application :
1. Click Add the device button.
2. Click Start button. (Start blink Z-Wave LED)
3. MC01-507L put into inclusion mode and it is added the device. when finish the add device, the Z-Wave LED was green light ON.(Stop blink Z-Wave LED)
4. The home screen of the app shown the added device.
5. Click the device icon. the screen detail view about information of added-device and can control device on this screen.
You can remove the device ether hardware button or application.
- hard ware button : Press the Add/Remove button(Start Z-Wave LED blink)
- Application :
1. Click Menu button on the screen detail view.
2. Click Remove the device button.
3. Click Remove button. (Start blink Z-Wave LED)
4. MC01-507L put into exclusion mode and it is removed the device. when finish the remove device, the Z-Wave LED was green light OFF. (Stop blink Z-Wave LED)
5. The home screen of the app shown the removed device.
Factory reset IoT hub
Press Reset button more than 5 seconds.
1. Select Controller Learn Mode Request command in the Emulator.
2. Click Kafka Send button.
3. Enter the parameter value.
4. Click Confirm button.
Please note that this is a user manual IoT hub from Mercury is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have IoT hub and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.