The following is an overview of the user manual for the Z-Wave product Door/Window Temperature & Humidity Sensor (MSE30Z)from Minoston. To view other Z-Wave products and manuals from Minoston follow that link.
Overview
This product is a Multipurpose Sensor, it have door/window sensor and Temperature Humidity sensor.
This product is a battery power ,It's sleep most of the time.
MSE30Z is a security enabled Z-Wave Plus™ device. A security Enabled Z-Wave Plus™ Controller must be used in order to fully utilize the product.
Security
As a Z-Wave Plus certified product, Door/Window Temperature & Humidity Sensor supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Minoston describes Door/Window Temperature & Humidity Sensor as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Battery powered using CR2450 batteries
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Adding Your Device To A Hub
The device support two methods of inclusion,When using a Z-Wave Plus™ certified controller choose Network Wide Inclusion or SmartStart,
Network Wide Inclusion To A Z-Wave™ Network
1,Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
2,When prompted by your primary controller, click the z-wave button three times in one second.
Function 2: quickly press 5x button :Wake-up the device
Factory reset Door/Window Temperature & Humidity Sensor
Press click Z-Wave button 3 times quickly,and hold the third time for at least 10 seconds. to restore the device to the factory.
(Node:Please use this procedure only when the network primary controller is missing or otherwise inoperable.)
Adding Your Device To A Hub
The device support two methods of inclusion,When using a Z-Wave Plus™ certified controller choose Network Wide Inclusion or SmartStart,
Network Wide Inclusion To A Z-Wave™ Network
1,Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
2,When prompted by your primary controller, click the z-wave button three times in one second.
SmartStart location
SmartStart QR code's location as follows: The device is compatible with SmartStart
SmartStart enabled products can be added into a Z-Wave™ network by scanning the Z-Wave QR Code found on the top of the outlet or the back of
the box with a controller providing SmartStart inclusion.No further action is required and the SmartStart product will be added automatically within
10 minutes of being switched on and in the network vicinity.
Please note that this is a user manual Door/Window Temperature & Humidity Sensor from Minoston is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Door/Window Temperature & Humidity Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.