Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Outdoor Smart Plug - 2 channel (MP24Z) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Outdoor Smart Plug - 2 channel (MP24Z)from Minoston. To view other Z-Wave products and manuals from Minoston follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Outdoor Smart Plug - 2 channel
SKU Code
MP24Z
Description
The MP24Zis a Z-Wave enabled device and is fully compatible with any Z-Wave Plus enabled network.Each module is designed to act as a repeater,which will re-transmit a radio frequency (RF) signal by routing the signal .around obstacles and radio dead spots to ensure that the signal is received at its intended destination.MP24Z is a security enabled Z-Wave plus device. A security Enabled Z-Wave Plus Controller must be used in order to fully utilize the product.
Version #
HW: 255 FW: 1.01 was the version certified
Certification #
ZC10-19116798
Certified
2019-11-25T15:25:03.322801
Z-Wave Version
6.71.01

Security

As a Z-Wave Plus certified product, Outdoor Smart Plug - 2 channel supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Unauthenticated

Features

Minoston describes Outdoor Smart Plug - 2 channel as having the following features:

  • Color
  • Outdoor Use
  • Firmware updatable via a compatible Z-Wave gateway
  • Switch Load Capacity Watts
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

ADD or Remove the MP24Z from the existing Z-Wave home control network with your primary controller.
---Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
---When prompted by your primary controller, click the PROG button five times in one second.

Factory reset Outdoor Smart Plug - 2 channel

MANUAL RESET
---Power off MP24Z
---keep holding the PROG button
---Power on,Press and keep holding the PROG button for no less than 10 seconds.
"Please use this procedure only when the network primary controller is missing or otherwise inoperable."

ADD or Remove the MP24Z from the existing Z-Wave home control network with your primary controller.
---Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
---When prompted by your primary controller, click the PROG button five times in one second.

Please note that this is a user manual Outdoor Smart Plug - 2 channel from Minoston is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Outdoor Smart Plug - 2 channel and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.