The following is an overview of the user manual for the Z-Wave product Outdoor Smart Plug (MP22Z)from Minoston. To view other Z-Wave products and manuals from Minoston follow that link.
Overview
Security
As a Z-Wave Plus certified product, Outdoor Smart Plug supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Minoston describes Outdoor Smart Plug as having the following features:
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Outdoor Use
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Page 5 in the UserManual
Tap the button on device once.
Tap the button on device twice.
Factory reset Outdoor Smart Plug
Press and hold the button for 20s.
Please note that this is a user manual Outdoor Smart Plug from Minoston is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Outdoor Smart Plug and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.