The following is an overview of the user manual for the Z-Wave product S2 In-wall Smart ON/OFF Switch (MS10ZS)from Minoston. To view other Z-Wave products and manuals from Minoston follow that link.
Overview
Security
As a Z-Wave Plus certified product, S2 In-wall Smart ON/OFF Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Minoston describes S2 In-wall Smart ON/OFF Switch as having the following features:
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Switch Type
- Electric Load Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
ADD the MS10Z from the existing Z-Wave home control network with your primary controller.
---Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
---When prompted by your primary controller, click the Up or Down button three times in one second.
Include MS10Z to/from a Z-Wave Gateway with supporting Security.The MS10Z can support the Primary Controller that implemented the security S2.
Remove the MS10Z from the existing Z-Wave home control network with your primary controller.
---Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
---When prompted by your primary controller, click the Up or Down button three times in one second.
Include MS10Z to/from a Z-Wave Gateway with supporting Security.The MS10Z can support the Primary Controller that implemented the security S2.
Factory reset S2 In-wall Smart ON/OFF Switch
Press click Z-Wave button 3 times quickly, and hold for at least 10 seconds at the third time to restore the device to the factory
Node:Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual S2 In-wall Smart ON/OFF Switch from Minoston is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have S2 In-wall Smart ON/OFF Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.