The following is an overview of the user manual for the Z-Wave product S2 Remote Control Switch (MR40Z)from Minoston. To view other Z-Wave products and manuals from Minoston follow that link.
Overview
Security
As a Z-Wave Plus certified product, S2 Remote Control Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Minoston describes S2 Remote Control Switch as having the following features:
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Watts
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Adding Your Device To A Hub
The device support two methods of inclusion,When using a Z-Wave Plus™ certified controller choose Network Wide Inclusion or SmartStart,
Network Wide Inclusion To A Z-Wave™ Network
1,Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
2,When prompted by your primary controller, click the Up or Down button six times in one second.
Adding Your Device To A Hub
The device support two methods of inclusion,When using a Z-Wave Plus™ certified controller choose Network Wide Inclusion or SmartStart,
Network Wide Inclusion To A Z-Wave™ Network
1,Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
2,When prompted by your primary controller, click the Up or Down button six times in one second.
quickly press 7x upper paddle: Wake up
Function 4: tap-tap-tap’and’hold to reset, LED indicator
Factory reset S2 Remote Control Switch
tap-tap-tap’and’hold to reset, LED indicator will blink red 5 times to confirm successful reset
(Node:Please use this procedure only when the network primary controller is missing or otherwise inoperable.)
SmartStart location
SmartStart QR code's location as follows: The device is compatible with SmartStart
SmartStart enabled products can be added into a Z-Wave™ network by scanning the Z-Wave™ QR Code found on the top of the outlet or the back of
the box with a controller providing SmartStart inclusion.No further action is required and the SmartStart product will be added automatically within
10 minutes of being switched on and in the network vicinity.
QR CODE
the QR code are sticked to the side of the case,DSK is included in the QR code.
DSK
The DSK code can be found on the DSK label which is attached on the packaging box.
Please note that this is a user manual S2 Remote Control Switch from Minoston is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have S2 Remote Control Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.