The following is an overview of the user manual for the Z-Wave product S2 Smart Dimmer Toggle Switch (MS13ZS)from Minoston. To view other Z-Wave products and manuals from Minoston follow that link.
Overview
- Manual or remote on/off control and dimming from your mobile device or computer (when included to a Z-Wave gateway controller)
- Z-Wave Plus with improved 500 chip for faster and safer wireless communication
- Works with most high-quality DIMMABLE LED, CFL, and incandescent bulbs
- Based on universal command classes - supported by most Z-Wave controllers
- May be associated and grouped with other Z-Wave devices for advanced home automation
- LED indicator to help locate the switch in dark space
- Simple elegant design with screwless snap-on wall plate included
- Built-in Z-Wave signal repeater for a stronger and more reliable network
Z-Wave Signal Frequency: 908.42 MHz
Power: 120 VAC, 60 Hz
Maximum Loads: 600W Single-gang, 500W Double-gang, 400W Triple-gang Incandescent, 150W CFL or LED
Minimum Load: 20W for LED and CFL bulbs
Range: Up to 100 feet line of sight
Operating Temperature: 32-104° F (0-40° C)
Installation and Use: Indoor only
Security
As a Z-Wave Plus certified product, S2 Smart Dimmer Toggle Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Minoston describes S2 Smart Dimmer Toggle Switch as having the following features:
- Color
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
ADD the MS13ZS from the existing Z-Wave home control network with your primary controller.
---Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
---When prompted by your primary controller, click the Up or Down button three times in one second.
Include MS13ZS to/from a Z-Wave Gateway with supporting Security.The MS13ZS can support the Primary Controller that implemented the security S2.
Remove the MS13ZS from the existing Z-Wave home control network with your primary controller.
---Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
---When prompted by your primary controller, click the Up or Down button three times in one second.
Include MS13ZS to/from a Z-Wave Gateway with supporting Security.The MS13ZS can support the Primary Controller that implemented the security S2.
Factory reset S2 Smart Dimmer Toggle Switch
Press click Z-Wave button 2 times quickly,and hold for at least 10 seconds. to restore the device to the factory
(Node:Please use this procedure only when the network primary controller is missing or otherwise inoperable.)
Please note that this is a user manual S2 Smart Dimmer Toggle Switch from Minoston is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have S2 Smart Dimmer Toggle Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.