The following is an overview of the user manual for the Z-Wave product S2 Smart ON/OFF Toggle Switch (MS12ZS)from Minoston. To view other Z-Wave products and manuals from Minoston follow that link.
Overview
Security
As a Z-Wave Plus certified product, S2 Smart ON/OFF Toggle Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Minoston describes S2 Smart ON/OFF Toggle Switch as having the following features:
- Color
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Watts
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset S2 Smart ON/OFF Toggle Switch
MANUAL RESET
---Power off MS12ZS
---keep holding the PROG button
---Power on,Press and keep holding the PROG button for no less than 10 seconds.
Please use this procedure only when the network primary controller is missing or otherwise inoperable."
ADD the MS12ZS from the existing Z-Wave home control network with your primary controller.
---Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
---When prompted by your primary controller, click the Up or Down button three times in one second.
Include MS12ZS to/from a Z-Wave Gateway with supporting Security.The MS12ZS can support the Primary Controller that implemented the security S2.
Remove the MS12ZS from the existing Z-Wave home control network with your primary controller.
---Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
---When prompted by your primary controller, click the Up or Down button three times in one second.
Include MS12ZS to/from a Z-Wave Gateway with supporting Security.The MS12ZS can support the Primary Controller that implemented the security S2.
Please note that this is a user manual S2 Smart ON/OFF Toggle Switch from Minoston is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have S2 Smart ON/OFF Toggle Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.