Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Smart Plug-2 Channel (MP20Z) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Smart Plug-2 Channel (MP20Z)from Minoston. To view other Z-Wave products and manuals from Minoston follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Smart Plug-2 Channel
SKU Code
MP20Z
Description
The 2 ports smart plug provides one Z-Wave outlet for remote controlled by controller through Z-Wave gateway for internet of thing service and can be configured in Z-Wave sensor network, if Z-Wave certified controller features remote access, you can now control your device from your mobile phone devices. the other outlet will be manual On/Off by push button on front. The outlets have maximum load for 600W Incandescent, ½ HP motor or 1200W resistive.
Version #
HW: 0 FW: 20.15 was the version certified
Certification #
ZC10-19066554
Certified
2019-06-20T18:40:05.888535
Z-Wave Version
6.51.06

Security

As a Z-Wave Plus certified product, Smart Plug-2 Channel supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Minoston describes Smart Plug-2 Channel as having the following features:

    • Color
    • Switch Type
    • Switch Load Capacity Current
    • Switch Load Capacity Watts
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Follow the instructions for your Z-Wave certified controller to include
    a device to the Z-Wave network.
    2. Once the controller is ready to include your device, press up and
    release the toggle to include it in the network.
    3. Once your controller has confirmed that the device has been included, refresh the
    Z-Wave network to optimize performance.
    4. The device is associated in the same group when it included in setting process.
    Now you can control your Z-Wave device according to groups, scenes, schedules
    and automation programmed.

    Factory reset Smart Plug-2 Channel

    1. Press and hold the top button for at least 3 seconds while you plug the smart switch into a receptacle.
    2. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.

    1. Follow the instructions for your Z-Wave certified controller to exclude
    a device from the Z-Wave network.
    2. Once the controller is ready to Exclude your device, press up and
    release the front button to exclude it from the network.

    Please note that this is a user manual Smart Plug-2 Channel from Minoston is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Plug-2 Channel and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.