The following is an overview of the user manual for the Z-Wave product Z-Wave Meter Plug (MP21ZP)from Minoston. To view other Z-Wave products and manuals from Minoston follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Meter Plug supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Minoston describes Z-Wave Meter Plug as having the following features:
- Color
- Switch Load Capacity Watts
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
ADD or Remove the MP21ZP from the existing Z-Wave home control network with your primary controller.
---Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
---When prompted by your primary controller, click the PROG button Three times in one second.
Include MP21ZP to/from a Z-Wave Gateway with supporting Security.The MP21ZP can support the Primary Controller that implemented the
Notice: Including a node ID allocated by Z-WaveTM Controller means “Add” or “Inclusion”. Excluding a node ID allocated by
Z-WaveTM Controller means “Remove” or “Exclusion”.
Factory reset Z-Wave Meter Plug
Press the button twice quickly and then press and hold the button 10S.device will reset
(Node:Please use this procedure only when the network primary controller is missing or otherwise inoperable)
ADD or Remove the MP21ZP from the existing Z-Wave home control network with your primary controller.
---Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
---When prompted by your primary controller, click the PROG button Three times in one second.
Include MP21ZP to/from a Z-Wave Gateway with supporting Security.The MP21ZP can support the Primary Controller that implemented the
Notice: Including a node ID allocated by Z-WaveTM Controller means “Add” or “Inclusion”. Excluding a node ID allocated by
Z-WaveTM Controller means “Remove” or “Exclusion”.
Please note that this is a user manual Z-Wave Meter Plug from Minoston is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Meter Plug and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.