The following is an overview of the user manual for the Z-Wave product Z-Wave Mini Plug (MP31Z)from Minoston. To view other Z-Wave products and manuals from Minoston follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Mini Plug supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Minoston describes Z-Wave Mini Plug as having the following features:
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Page 5 in the UserManual
Tap the button on device once.
Tap the button on device twice.
Factory reset Z-Wave Mini Plug
Press and hold the button for 20s.
Note: Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Z-Wave Mini Plug from Minoston is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Mini Plug and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.