The following is an overview of the user manual for the Z-Wave product Itb-5088 (ITB-5088)from MITSUMI. To view other Z-Wave products and manuals from Mitsumi follow that link.
Overview
Security
As a Z-Wave Plus certified product, Itb-5088 supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
- S2 Authenticated
- S2 Unauthenticated
Features
Mitsumi describes Itb-5088 as having the following features:
- Sensors
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To add a device to the Z-Wave network, press the “Inclusion” button in
the Android Controller Application. This will put the gateway into
Inclusion Mode. Then a gateway operation dialog will appear in the
Android Controller Application. The gateway operation dialog will be
displayed during the Inclusion Mode.
To stop the Inclusion Mode, press the “Abort” button in the gateway
operation dialog, or wait for one minute and the Inclusion Mode will
automatically stop. When the Inclusion Mode has stopped, the gateway
operation dialog will automatically disappear.
To add an IoT gateway into another Z-Wave network as a
secondary controller or inclusion controller, press “Learn Mode
Classic” or “Learn Mode NWI” in the Settings dialog. A gateway
Operation dialog will appear and will be displayed during the
Learn Mode.
To abort the Learn Mode, press “ABORT”. When the Learn Mode
has been stopped, the gateway operation dialog will automatically
disappear.
Factory reset Itb-5088
Press “RESET” in the Factory Default Reset dialog. This will reset
the Z- Wave chip, and the gateway will show “DEVICE RESET
LOCALLY NOTIFICATION” after the restart.
If this controller is the primary controller for your network,
resetting it will result in the nodes in your network becoming
orphaned, and it will be necessary after the reset to exclude and
re-include all of the nodes in the network. If this controller is being
used as a secondary controller in the network, use this procedure
to reset this controller only in the event that the network primary
controller is missing or otherwise inoperable.
To remove a device from the Z-Wave network, press the “Exclusion”
button in the Android Controller Application. This will put the gateway
into Exclusion Mode. A gateway operation dialog will appear in the
Android Controller Application. The gateway operation dialog will be
displayed during the Exclusion Mode.
To abort the Exclusion, press the “Abort” button in the gateway
operation dialog, or wait for one minute and the Exclusion Mode will
automatically stop. When the Exclusion Mode has stopped, the gateway
operation dialog will automatically disappear.
Please note that this is a user manual Itb-5088 from MITSUMI is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Itb-5088 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.