The following is an overview of the user manual for the Z-Wave product Window Sensor (FGT-0001)from MITSUMI. To view other Z-Wave products and manuals from Mitsumi follow that link.
Overview
Security
As a Z-Wave Plus certified product, Window Sensor supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Mitsumi describes Window Sensor as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: You can check the DSK and QR code on the label by removing the bottom cover of this product.
1 Set the controller in "Add (Inclusion)" mode.
(For the operation procedure, see the instruction manual of the controller.)
2 Push the Operation switch once. The LED blinks green and the registration operation start.
* If the LED does not brink green, remove the battery, check the insertion direction, and insert it again
* If that doesn't work, try inserting a new battery.
(The included battery is a sample. Battery life may be shorter than regular batteries on the market.)
3 Check the connection using a controller or a dedicated application.
1 Remove the Bottom cover.
2 Set the controller in "Remove (Exclusion)" mode.
(For the operation procedure, see the instruction manual of the controller.)
3 Push the Operation switch once. The LED blinks red and the remove operation start.
4 LED turns off when removed. Check the disconnection using a controller or a dedicated application.
Attach the magnet onto the window glass, and the sensor onto the window sash.
※ Allow a space of 10 mm from the top of this product.
Factory reset Window Sensor
Please use this procedure only in the event that the primary controller is lost. All the settings and the controller information are cleared to return to the factory default.
1 Remove the Bottom cover.
2 Press and hold the Operation SW for about 10 seconds. The LED light up when initialization begins.
3 Push the Operation switch once and release it immediately. The reset is complete when the LED brink
green. Push and release the Operation switch again to turn off the LED.
Please note that this is a user manual Window Sensor from MITSUMI is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Window Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.