The following is an overview of the user manual for the Z-Wave product Smart Lock wireless I/F unit (Z-Wave/BLE) (CVBT-ZW01)from MIWA LOCK. To view other Z-Wave products and manuals from Miwa Lock follow that link.
Overview
Security
As a Z-Wave Plus certified product, Smart Lock wireless I/F unit (Z-Wave/BLE) supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
Features
Miwa Lock describes Smart Lock wireless I/F unit (Z-Wave/BLE) as having the following features:
- Color
- Communications Connections
- Communications Protocol
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: CVBT-ZW01_install_manual, P.2 "Part names and functions"
i. Hold down the GATEWAY connection button until the GATEWAY connection status lamp blinks blue, the I/F unit becomes a waiting mode of connecting with Z-Wave Gateway.
ii. The connecting is completed when the lamp blinking stops and turns on blue.
a. When exclusion the I/F unit from Z-Wave network, unplug the power supply after the operation of the application.
b. While hold down the GATEWAY connection button, supply power to the I/F unit. When GATEWAY connection status lamp blinks blue, release
i. Insert the plug of the supplied AC adapter to the DC Input as far as will go.
ii. Connect the AC adapter into an electrical outlet. (The power supply is AC 100V).
Two lamps will blink red intermittently.
Factory reset Smart Lock wireless I/F unit (Z-Wave/BLE)
a. Unplug the power supply of the I/F unit.
b. While Hold down both the LOCK connection button and GATEWAY connection button, supply power to the I/F unit. Keep the holding buttons during about 5 seconds, two lamps will blink blue. Release from both bu
Please note that this is a user manual Smart Lock wireless I/F unit (Z-Wave/BLE) from MIWA LOCK is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Lock wireless I/F unit (Z-Wave/BLE) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.