The following is an overview of the user manual for the Z-Wave product Radio Base Modul (MTBAS-100-WL)from myTEM SmartHome. To view other Z-Wave products and manuals from myTEM SmartHome follow that link.
Overview
The myTEM Radio Base module must be powered by a 24 VDC power supply and connected to a myTEM Smart Server via the CAN bus. The device is installed in a con-trol cabinet, mounted on a 35 mm DIN rail.
Several myTEM Radio Base modules can be used with the same myTEM Smart Server on the CAN bus. This can be useful, for example, if apartments are to have their own separate Z-Wave networks with a central server.
Security
As a Z-Wave Plus certified product, Radio Base Modul supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
- S2 Authenticated
- S2 Unauthenticated
Features
myTEM SmartHome describes Radio Base Modul as having the following features:
- Communications Protocol
- Gateway Has Preferred Partners
- Supported Notification Types
- Sensors
- Communications Connections
- Supported Meter Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To set the Radio Server to Learn Mode use myTEM ProgTool.
1. Create or open a project
2. Connect to Radio Server
3. Start Z-Wave Manager
4. Click
For more information see myTEM ProgTool manual.
To include a device into a Z-Wave network use myTEM ProgTool.
1. Create or open a project
2. Connect to Radio Server
3. Start Z-Wave Manager
4. Click
For more information see myTEM ProgTool manual.
To exclude a device from a Z-Wave network use myTEM ProgTool.
1. Create or open a project
2. Connect to Radio Server
3. Start Z-Wave Manager
4. Click
For more information see myTEM ProgTool manual.
To add the myTEM Radio Server or myTEM Smart Server into an existing network set the Controller of the existing network into inclusion mode than click on «Learn Mode» in the UI (for more informatino see manual).
To remove the myTEM Radio Server or myTEM Smart Server from an existing network set the Controller of the existing network into inclusion mode than click on «Learn Mode» in the UI (for more informatino see manual).
SmartStart location
SmartStart QR code's location as follows: The DSK is displayed by the User Interface.
Factory reset Radio Base Modul
To reset Radio Server use myTEM ProgTool.
1. Create or open a project
2. Connect to Radio Server
3. Start Z-Wave Manager
4. Click
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
For more information see myTEM ProgTool manual.
Please note that this is a user manual Radio Base Modul from myTEM SmartHome is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Radio Base Modul and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.