The following is an overview of the user manual for the Z-Wave product Radio Server (MTSER-100-WL)from myTEM SmartHome. To view other Z-Wave products and manuals from myTEM SmartHome follow that link.
Overview
The myTEM Radio Server is the heart of your intelligent home. You have access to the controller via the very simple, user-friendly myTEM Smart Home App or via the extremely powerful myTEM ProgTool. These access options allow you to assign suitable tasks and functions to all devices and to set them up for your needs. Depending on your needs, you can customize your home using predefined scenes or completely individually according to your wishes.
Security
As a Z-Wave Plus certified product, Radio Server supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
- S2 Authenticated
- S2 Unauthenticated
Features
myTEM SmartHome describes Radio Server as having the following features:
- Gateway Has Preferred Partners
- Communications Connections
- Communications Protocol
- Sensors
- Supported Meter Type
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To include a device into a Z-Wave network use myTEM ProgTool.
1. Create or open a project
2. Connect to Radio Server
3. Start Z-Wave Manager
4. Click
For more information see myTEM ProgTool manual.
To exclude a device from a Z-Wave network use myTEM ProgTool.
1. Create or open a project
2. Connect to Radio Server
3. Start Z-Wave Manager
4. Click
For more information see myTEM ProgTool manual.
To set the Radio Server to Learn Mode use myTEM ProgTool.
1. Create or open a project
2. Connect to Radio Server
3. Start Z-Wave Manager
4. Click
For more information see myTEM ProgTool manual.
Factory reset Radio Server
To reset Radio Server use myTEM ProgTool.
1. Create or open a project
2. Connect to Radio Server
3. Start Z-Wave Manager
4. Click
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
For more information see myTEM ProgTool manual.
Please note that this is a user manual Radio Server from myTEM SmartHome is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Radio Server and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.