The following is an overview of the user manual for the Z-Wave product Radio Socket CH (MTSOC-100CH-WL)from myTEM SmartHome. To view other Z-Wave products and manuals from myTEM SmartHome follow that link.
Overview
Security
As a Z-Wave Plus certified product, Radio Socket CH supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
myTEM SmartHome describes Radio Socket CH as having the following features:
- Supported Meter Type
- Supported Notification Types
- Switch Load Capacity Current
- Switch Load Capacity Volt-Ampere
- Firmware updatable via a compatible Z-Wave gateway
- Electric Load Type
- Sensors
- Switch Load Capacity Watts
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Radio Socket CH
Remark: It is recommended to use the primary controller of the previous network unless it is no longer available or damaged.
To start the Remove process press the button four times in quick succession. The LED flashes red and then the new status is:
Add: The LED lights up briefly in green
Remove: The LED lights up briefly in red
Inclusion (Add)
To include (Add) the device to a Z-Wave network, press the button four times in quick succession. When the device is in Add mode, the LED flashes green. When finished, the new status is:
Add: The LED lights up briefly in green
Remove: The LED lights up briefly in red
Exclusion (Remove)
To exclude (Remove) the device from a Z-Wave network, press the button four times in quick succession. When the device is in Add mode, the LED flashes green. When finished, the new status is:
Add: The LED lights up briefly in green
Remove: The LED lights up briefly in red
Please note that this is a user manual Radio Socket CH from myTEM SmartHome is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Radio Socket CH and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.