Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Radio Socket (MTSOC-100-WL) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Radio Socket (MTSOC-100-WL)from myTEM SmartHome. To view other Z-Wave products and manuals from myTEM SmartHome follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Radio Socket
SKU Code
MTSOC-100-WL
Description
The myTEM Radio Socket is a universal, Z-Wave compatible switch/adapter for loads up to 3'600 watts (type F, EU). The power and energy consumption of the connected device is measured. In addition, a temperature and humidity sensor is integrated. These values are reported to the central controller and can be used to control other functions.
Version #
HW: 1 FW: 1.00 was the version certified
Certification #
ZC10-19056472
Certified
2019-03-20T01:52:48.439565
Z-Wave Version
6.71.03

Security

As a Z-Wave Plus certified product, Radio Socket supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Authenticated
  • S2 Unauthenticated

Features

myTEM SmartHome describes Radio Socket as having the following features:

  • Sensors
  • Switch Load Capacity Volt-Ampere
  • Electric Load Type
  • Supported Meter Type
  • Switch Load Capacity Current
  • Switch Load Capacity Watts
  • Firmware updatable via a compatible Z-Wave gateway
  • Supported Notification Types
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

Factory reset Radio Socket

Remark: It is recommended to use the primary controller of the previous network unless it is no longer available or damaged.

To start the Remove process press the button four times in quick succession. The LED flashes red and then the new status is:
Add: The LED lights up briefly in green
Remove: The LED lights up briefly in red

Inclusion (Add)
To include (Add) the device to a Z-Wave network, press the button four times in quick succession. When the device is in Add mode, the LED flashes green. When finished, the new status is:
Add: The LED lights up briefly in green
Remove: The LED lights up briefly in red

Exclusion (Remove)
To exclude (Remove) the device from a Z-Wave network, press the button four times in quick succession. When the device is in Add mode, the LED flashes green. When finished, the new status is:
Add: The LED lights up briefly in green
Remove: The LED lights up briefly in red

Please note that this is a user manual Radio Socket from myTEM SmartHome is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Radio Socket and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.