The following is an overview of the user manual for the Z-Wave product Radio Switch Dimmer (MTSWD-100-WL)from myTEM SmartHome. To view other Z-Wave products and manuals from myTEM SmartHome follow that link.
Overview
The power and energy consumption of the connected device is measured. Three additional digital inputs and the programmable behavior to the wireless commands allow flexible use in the house.
The device is intended for installation in a flush-mounted box, e.g. behind light switches or sockets.
Security
As a Z-Wave Plus certified product, Radio Switch Dimmer supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
myTEM SmartHome describes Radio Switch Dimmer as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Watts
- Electric Load Type
- Switch Load Capacity Current
- Switch Load Capacity Volt-Ampere
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: The QR code located on the side of the housing.
1. Activate the “Add” ” mode on your controller.
2. Press a button connected to input I3 four times in quick succession to start include (“Add”). If a switch is used instead of the button, it must be changed accordingly eight times.
3. Alternatively you can press the small lever (T) four times in quick succession with an insulated pen to start “Add”.
When the device is in the “Add” mode, the LED flashes green. When finished, the new status is:
Add: The LED lights up briefly in green
Remove: The LED lights up briefly in red
1. Activate the “Remove” mode on your controller.
2. Press a button connected to input I3 four times in quick succession to start exclude (“Remove”). If a switch is used instead of the button, it must be changed accordingly eight times.
3. Alternatively you can press the small lever (T) four times in quick succession with a insulated pen to start “Remove”.
When the device is in the “Remove” mode, the LED flashes red. When finished, the new status is:
Add: The LED lights up briefly in green
Remove: The LED lights up briefly in red
Factory reset Radio Switch Dimmer
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Power-up the device and then press the small lever (T) for 10 seconds with an insulated pen.
Reset: The LED lights up briefly in red
Please note that this is a user manual Radio Switch Dimmer from myTEM SmartHome is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Radio Switch Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.