The following is an overview of the user manual for the Z-Wave product Radio Switch Dual (MTSWI-100-WL)from myTEM SmartHome. To view other Z-Wave products and manuals from myTEM SmartHome follow that link.
Overview
Two additional digital inputs and the programmable be-havior to the wireless commands allow flexible use in the house. At the same time, the device also serves as a Z-Wave repeater to improve range and stability of the Z-Wave network.
The device is intended for installation in a flush-mounted box, e.g. behind light switches or sockets.
Security
As a Z-Wave Plus certified product, Radio Switch Dual supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
myTEM SmartHome describes Radio Switch Dual as having the following features:
- Loads Controlled
- Firmware updatable via a compatible Z-Wave gateway
- Supported Meter Type
- Supported Notification Types
- Switch Load Capacity Current
- Switch Load Capacity Volt-Ampere
- Electric Load Type
- Switch Load Capacity Watts
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Radio Switch Dual
If the myTEM Radio Switch Dual shows status “Add”, the
“Remove” can be performed with any controller in the
network or with the help of a new controller. However it is
recommended to use the primary controller of the previous
network unless it is no longer available or damaged.
“Remove” deletes the memory chip, including all Z-Wave
network and custom configuration settings.
Automatic inclusion (“Add”)
The device supports the so-called auto-inclusion. To use this function the device must be in factory default.
1. Activate the “Add” mode on your controller.
2. Turn on the power and the unit starts in its own “Add” mode for 30 seconds. If the connection is successful, the device registers on the controller.
When the device is in the “Add” mode, the LED flashes green. When finished, the new status is:
Add: The LED lights up briefly in green
Remove: The LED lights up briefly in red
Manual inclusion (“Add”)
1. Activate the “Add” ” mode on your controller.
2. When 110 – 230 VAC is used, press a button connected to input I1 or I2 four times in quick succession to start include (“Add”). If a switch is used instead of the button, it must be changed accordingly eight times.
3. Alternatively, when 24 VDC is used, you can press the small lever (T) four times in quick succession with a pen to start “Add”.
When the device is in the “Add” mode, the LED flashes green. When finished, the new status is:
Add: The LED lights up briefly in green
Remove: The LED lights up briefly in red
Manual exclusion (“Remove”)
1. Activate the “Remove” mode on your controller.
2. When 110 – 230 VAC is used, press a button connected to input I1 or I2 four times in quick succession to start exclude (“Remove”). If a switch is used instead of the button, it must be changed accordingly eight times.
3. Alternatively, when 24 VDC is used, you can press the small lever (T) four times in quick succession with a pen to start “Remove”.
When the device is in the “Remove” mode, the LED flashes
red. When finished, the new status is:
Add: The LED lights up briefly in green
Remove: The LED lights up briefly in red
Please note that this is a user manual Radio Switch Dual from myTEM SmartHome is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Radio Switch Dual and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.