The following is an overview of the user manual for the Z-Wave product Radio Switch Shutter Plus (MTSWIS-101-WL)from myTEM SmartHome. To view other Z-Wave products and manuals from myTEM SmartHome follow that link.
Overview
The device is intended for installation in a flush-mounted box.
Security
As a Z-Wave Plus certified product, Radio Switch Shutter Plus supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
myTEM SmartHome describes Radio Switch Shutter Plus as having the following features:
- Electric Load Type
- Switch Load Capacity Current
- Firmware updatable via a compatible Z-Wave gateway
- Supported Notification Types
- Z-Wave Scene Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Manual exclusion (“Remove”)
1. Activate the “Remove” mode on your controller.
2. When 110 – 230 VAC is used, press a button connected to input I1 or I2 four times in quick succession to start exclude (“Remove”). If a switch is used instead of the button, it must be changed accordingly eight times.
3. Alternatively, when 24 VDC is used, you can press the small lever (T) four times in quick succession with a pen to start “Remove”.
When finished, the new status is:
Add: The LED lights up briefly in green
Remove: The LED lights up briefly in red
Factory reset Radio Switch Shutter Plus
Reset to factory default
If the myTEM Radio Switch Dual Plus shows status “Add”, the “Remove” can be performed with any controller in the network or with the help of a new controller. However it is recommended to use the primary controller of the previous network unless it is no longer available or damaged.
“Remove” deletes the memory chip, including all Z-Wave network and custom configuration settings.
Manual inclusion (“Add”)
1. Activate the “Add” mode on your controller.
2. When 110 – 230 VAC is used, press a button connected to input I1 or I2 four times in quick succession to start include (“Add”). If a switch is used instead of the button, it must be changed accordingly eight times.
3. Alternatively, when 24 VDC is used, you can press the small lever (T) four times in quick succession with a pen to start “Add”.
When the device is in the “Add” mode, the LED flashes green. When finished, the new status is:
Add: The LED lights up briefly in green
Remove: The LED lights up briefly in red
SmartStart location
SmartStart QR code's location as follows: The QR code is located on the side of the housing.
Please note that this is a user manual Radio Switch Shutter Plus from myTEM SmartHome is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Radio Switch Shutter Plus and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.