The following is an overview of the user manual for the Z-Wave product Bl1000hw (H03HG8)from NEC. To view other Z-Wave products and manuals from NEC follow that link.
Overview
So this can be used only in KDDI's network.
This also has the following features
・Wireless router technology
・Number of USB Ports：USB3.0 × 1 port
・Number of Ether port : 1Gbps × 3port type RJ45
・Dial-up port ：1port type RJ11
When you use this device as the Z-Wave gateway, you have to subscribe the KDDI's FTTH service and optional service.
Security
As a Z-Wave Plus certified product, Bl1000hw supports Z-Wave S2 security. The following security modes are directly supported:
Features
NEC describes Bl1000hw as having the following features:
- Gateway Has Preferred Partners
- Supported Notification Types
- Color
- Sensors
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To include, select the kind of device by Smartphone application, and it induces to push down the program switch of device.
The detail operation and screen transition is described on the Product Manual.
Please refer page 2 to 3.
To exclude the registered device by Smartphone application, and it induces to push down the program switch of device.
The detail operation and screen transition is described on the Product Manual.
Please refer page 8 to 10.
Factory reset Bl1000hw
1. Unplug this product and wait for approximately 10 seconds.
2. Hold down the reset button (It is placed at the bottom of the back side) and keep holding it .
3.Plug in this product.(Keep holding the reset button.)
About 20 seconds after , All front lumps blink 3 times at the same time , After that you may release your hands from the reset button.
※Don't unplug this product until completely initialized, as it may be the cause of breakdown.
""If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.""
Please note that this is a user manual Bl1000hw from NEC is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Bl1000hw and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.