The following is an overview of the user manual for the Z-Wave product Z-Wave Single Button (ZA-116011)from Ness. To view other Z-Wave products and manuals from Ness follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Single Button supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Ness describes Z-Wave Single Button as having the following features:
- Battery powered using CR2450 batteries
- Color
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Page 7.
Ness Z-Wave Single Button (ZWSB) is a SmartStart-enabled device allowing it to be added into a Z-Wave network by scanning its Z-Wave QR Code with a controller providing SmartStart inclusion. No further action is required and the SmartStart product will be added automatically within 10 minutes of being switched on in the network vicinity.
Adding the device into a Z‑Wave Network Inclusion
To add the device to the Z-Wave network:
1) Power on the device and ensure it has been factory defaulted.
2) Set the primary controller into inclusion mode.
3) Click the Action Button once to enter inclusion mode. Red LED: fast flashing. Inclusion mode can be cancelled by clicking the Action Button again before the controller starts inclusion mode. Red LED stops flashing.
4) If your Z-Wave controller supports S2 Access encryption and DSK, enter the first 5 digits of the DSK located at bottom of the QR image.
5) If Inclusion is successful:
Red LED stops fast flashing.
Green LED turns on for 2 seconds.
Removing The device from a Z‑Wave Network The Exclusion process is the same as Inclusion however your Z-Wave controller must be in Exclusion mode.
You may need to refer to your Z-Wave gateway/controller’s instructions for removing devices.
Exclusion To remove the device from the Z-Wave network:
1) The device is powered
2) Set the primary controller into Exclusion mode.
3) Click the Action Button once.
4) If Exclusion is successful:
Red LED stops fast flashing.
Green LED turns on for 2 seconds.
2. Wake-up
To manually wake up the ZWSB, press and hold the Action Button for 3 seconds until the Blue LED turns on, then release the button.
Factory reset Z-Wave Single Button
3. Factory Default
To reset Ness ZWSB to factory default settings, press and hold the Action Button for at least 20 seconds. Release the button when the Blue LED turns off (20 seconds). The Green LED will flash once to indicate successful reset.
Releasing the Action Button while the Blue LED is on cancels the reset process.
Please note that this is a user manual Z-Wave Single Button from Ness is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Single Button and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.