The following is an overview of the user manual for the Z-Wave product Data Collecting Module DCM-5.1.1-Z (DCM-5.1.1-Z)from NEVOTON. To view other Z-Wave products and manuals from NEVOTON follow that link.
Overview
The data collecting module NEVOTON DCM-5.1.1-Z can manage with 5 sensors at the same time, as well as it is able to control one external device (has one switching relay).
List of the types of respondents sensors corresponds to the modern equipment of industrial automation:
1. Platinum thermistor 50, 100, 500, 1000. Accuracy: 0,1°С, measurement error: above 0,1%
2. Copper thermistor 50, 100, 500, 1000. Accuracy: 0,1°С, measurement error: above 0,1%
3. Thermocouples: R,S,B,J,T,E,K,N,A,L,M types. Accuracy: 1°С, measurement error: above 0,1%
4. DC current signal 0..5 mA. Measurement error: above 0,1%
5. DC current signal 0..20 mA. Measurement error: above 0,1%
6. DC current signal 4..20 mA. Measurement error: above 0,1%
7. DC voltage signal 0..10 V. Measurement error: above 0,1%
8. DC voltage signal -50..+50 mV Measurement error: above 0,1%
9. DC voltage signal 0..1 V Measurement error: above 0,1%
10. Dry contact
11. Flap position sensor 0..900 Ohm
12. Flap position sensor 0..2000 Ohm
Security
As a Z-Wave Plus certified product, Data Collecting Module DCM-5.1.1-Z supports Z-Wave S2 security. The following security modes are directly supported:
Features
NEVOTON describes Data Collecting Module DCM-5.1.1-Z as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
For adding the device to the Z-Wave network the triple click of the Set button is needed.
To remove the device from the Z-Wave network click the Set button trice again.
Factory reset Data Collecting Module DCM-5.1.1-Z
Hold the Set button pushed for 5 seconds, then push it three times shortly. The Z-Wave indicator alternately flashes red and green. After that the triple-click is needed.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Data Collecting Module DCM-5.1.1-Z from NEVOTON is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Data Collecting Module DCM-5.1.1-Z and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.