The following is an overview of the user manual for the Z-Wave product Bridge (Nexa Bridge v1)from Nexa. To view other Z-Wave products and manuals from NEXA follow that link.
Overview
Use the the Z-Wave for devices that needs two-way communication, choose 433 MHz for
System Nexa devices and sensors and with 868 MHz you can connect your smoke alarms to Nexa Bridge.
The outstanding App for for your smartphone gives you total control of everything in your house. Nexa Bridge is not in need of internet connection to work while you are at your home network and all scenarios will run offline at all time.
Nexa Bridge will make your home the smartest!
Security
As a Z-Wave Plus certified product, Bridge supports Z-Wave S2 security. The following security modes are directly supported:
Features
NEXA describes Bridge as having the following features:
- Communications Connections
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
At the home menu, choose More, Z-Wave, Include Z-Wave
At the home menu, choose More, Z-Wave, Exclude Z-Wave
At the home menu, choose More, Z-Wave, Enter Learn mode
Factory reset Bridge
Power up device, wait 7 minutes, press and hold reset button 10 seconds on the backside of the device.
Please note that this is a user manual Bridge from Nexa is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Bridge and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.